Pistons and Sump
Clean Head and Valve Job
First Mock up
Finally together
Getting ready to go in
Progress
Beautifully clean neck (all powdercoated)
Battery Box
Starting to wire it up
Front break Sys on
New Advance in
Making everything modular
All systems wired
New Dash
Turned out manifolds for carbs
Seat on, tanks on - no carbs yet
33
First Carb on
Fuel Sys hooked up
Speedo and tach hooked up and functioning
Upgraded to Electronic I
The Finished Product
New Tail light
The Dash
Oil Bag open
Ahhh...so pretty
Clean Head
Honed Jugs
Bottom together and ready to receive
All Black is Powdercoated
Frame just back from Powdercoater
Engine and Forks on
Rear Break Sys and Battery Box
Forward Controls on
Rear Fender and Wheel
Both wheels on
20
Chimarra Haseigbh
New Points in
New Harley Dash Mounted and wired
Pulling it all together
28
Two Brand New 34mm Mikunis
New Dash Cover just back fro powdercoating
Other side
First exhaust pipe on and chain
Everything and fake oil bag on
very close
The Finished Product
Sweet Ride
A little touch up
Dual discs on and working
She can stop now...
Kelt Specs
- New Model A Tail Light
- New Battery
- New Brake Pads all around
Frame
- Weld on Hard Tail
- Four inch strecth
- Powdercoat (flat black texture) by Protech of Pinehurst, NC
- New Neck Bearings
- New Fork Seals
- Stainless Steel Battery Box
- Custom Aluminum Forward Controls, Tank Caps, Grips and Fender Struts
- Fake Oil Bag that opens
- New Tires, Front and Rear
- Upgraded to dual disc front brakes right before selling
Tank, Fender and Oil Bag
- Scalloped metal, Powdercoat (clear, high gloss) by Protech of Pinehurst, NC
Engine
- 150 Miles on rebuild
- All Powdercoating (flat black, textured) by Protech of Pinehurst, NC
- New piston rings
- All new seals and gaskets
- All new upper bolts and nuts
- New Points and Advance (just changed out the points for a new Boyer Bransden Micro Power Micro Digital Ignition
System with Programmed digital advance curve, Low power draw, special high voltage dual output
coil (45KV)).
- New sump and all new filters
- New Wiring Harness, Coils, Condensors, Safety Relay, Fuses, Ignition, Spark Plugs and Plug Wires
- Two new Mikuni 34mm CV carbs
- New Petcock, Fuel lines, filter
- New Chain
- New handlebar controls
- New Throttle Cable from Motion Pro
Thanks to
- Alex at Lowmaster LLC, Sanford, NC
- Jason's Tire and Auto, Aberdeen, NC
- Pinehurst Blacksmith
- Protech Powdercoating
- Sandhills Community College Automotive Department
- G&L Choppers
- Motion Pro
- Mike's XS
- Ebay, Craiglist, yadda yadda yadda